How To's

Why won’t my IFP accept my WIFI password?
Password characters that are supported in any combination are listed below. Highlighted in green are compatible in a WIFI password.   Numeric values:...
Thu, 29 Oct, 2020 at 8:46 AM
Advancing Google Slides Presentation Touch Issue
Issue: While in Presenter Mode, when swiping right or left on the Viewboard the document will not advance or go back. Solutions: Using 1 finger or the...
Fri, 8 Oct, 2021 at 10:21 PM
Viewboad in Safe Mode
Issue: The ViewBoard boots up with Safe mode displayed at the bottom-left corner of the screen This message can appear when the Volume Down (#7...
Thu, 4 Apr, 2024 at 12:20 PM
How can I lock the control buttons to prevent unwanted and accidental presses?
Refer to the following article to enable special button lock options.   The buttons can be locked by pressing the following front panel buttons in sequ...
Sun, 20 Oct, 2019 at 5:08 PM
Low Volume from Line Out on ViewBoard
Applies To: IFP50-3 Series ViewBoards IFP52-1C Series ViewBoards Issue Description When connecting the Line Out to an external speaker or audio...
Fri, 27 Jan, 2023 at 7:21 AM
How to enter the debug menu on an IFP without the remote
If a remote control is not available then you can enter the debug menu on an IFP unit using the step below.  1. Open IFP's Settings 2. Tap Sys...
Fri, 9 Jun, 2023 at 9:13 AM
Does Win 10 connect support IFP7550 touch back control?
Yes, you can follow below steps: 1. Under Action Center, click Connect button. 2. Click the name of the device you're trying to project. 3. Check the...
Wed, 9 Jan, 2019 at 3:15 AM
Firmware Flash Instructions IFP52-2ED
A USB firmware flash is used when the OTA (over-the-air) update is not a viable option or a complete reflash of the firmware is required.  If you would...
Mon, 24 Jun, 2024 at 12:19 PM
VPC Windows Setup without Ethernet or WIFI
How to set up Windows without an ethernet connection or WIFI enabled.   Please use any Windows Compatible External USB WIFI module with the VPC to access ...
Tue, 15 Oct, 2024 at 2:19 PM
IFP105S - Why Is My OPS showing No Signal After the Firmware Update?
Issue: With the latest firmware version 20240429, the Viewboard's OPS 5K detect setting is defaulted to 5K, causing a "No Signal" issue when u...
Tue, 13 Aug, 2024 at 3:53 PM