Interactive Flat Panel

Why my MacBook with MacOS v10.11 can't get touch feedback from IFP7550?
It's a software limitation from MacOS. Please upgrade MacOS to v10.13 or later to solve the issue.
Wed, 9 Jan, 2019 at 3:14 AM
What to do as it shows a warning message “Program not activated, will exit in 30 minutes” when running vBoard?
vBoard will be activated automatically while Internet in connected. Please make sure your IFP display is well connected to Internet.
Wed, 9 Jan, 2019 at 3:14 AM
How to install my IR audio system and avoid IR interference from IFP7550?
Both touch module and remote control in IFP7550 are based on IR technology with transmitter and receiver. The IR wave length of touch module is 850nm and 9...
Wed, 9 Jan, 2019 at 3:14 AM
Touch not working on CDE7051-TL with external device, how can I do?
Check connection and ports, if connected to VGA, USB will be from PC to Touch 1. Disconnect and reconnect the USB cable and make sure that Windows loads ap...
Wed, 9 Jan, 2019 at 3:15 AM
Is it possible to select different time zone for date
The default time zone is +8 which can be changed at the initial setting stage by Set up wizard of ViewBoard Launcher. It will be auto sync-up later with in...
Wed, 9 Jan, 2019 at 3:15 AM
Can CDE7061T VGA out show the annotation layer to second display?
No, CDE7061T VGA Out only bypass the signal from VGA in 1 and VGA in 2, the annotation won’t be shown on second display.
Wed, 9 Jan, 2019 at 3:15 AM
How can I setup touch on extended display?
Windows 10 1. Connect the external displays with video cables and USB cables from the PC. The USB cable must be connected to enable touch functionality.  ...
Wed, 20 Jul, 2022 at 1:07 PM
Can IFP7550 HDMI out show the annotation layer to second display?
Yes, the HDMI out on the IFP7550 will show the annotations on the second display.
Wed, 9 Jan, 2019 at 3:15 AM
How to disable IFP7550 USB port
You need to upgrade firmware to 20180403 or later version, you can download firmware from ViewSonic website. After done the firmware upgrade, you need to pr...
Wed, 9 Jan, 2019 at 3:15 AM
My IFP7550 appears "The device has been locked, please use the U disk to unlock", how can I do?
Please refer below steps to unlock. 1. Format the USB drive to FAT32. 2. Unzip Unlock.zip and copy to the USB drive root. 3. Insert the USB to IFP50 USB ...
Wed, 9 Jan, 2019 at 3:15 AM